Source IEC Connection


First attempt putting plug on Source having new jacket compound. Notes:
1) Skip usual automatic stripper. Use smaller hand tool that lets you get down lower and strip enough insulation off
2) I ended up removing the outer jacket I was planning to leave on and close the plug over. I happened to strip just enough green jacket off so I could close the plug down onto the jacket and NOT the individual conductors
3) Make sure you cut away the shield and drain so they don’t creep up and short anything
4 On the wall-plug end you insert the drain with the ground wire into the plug.

Leave a Reply

Your email address will not be published. Required fields are marked *