Water Heater Flame Gas Short Cycle Ignitor Problem Sensor Troubleshoot Repair AO Smith Igniter


Say Thanks! Make a Donation to Support My Channel Here:
Troubleshoot and Repair Your Water Heater
BUY SHAVING SUPPLIES:
SUBSCRIBE:
VIEW A STRAIGHT RAZOR SHAVE:
VIEW A SAFETY RAZOR SHAVE:
STROPPING VIDEO:
Does your Water Heater ignitor glow, Produce Flame at Main Burner Assembly, then shut down and start the cycle over several times without staying on? If so Chances are the Flame Sensor is Covered with Oxidation or Residue . I will show you how to remove the Main Burner Assembly Sand off the residue form the Flame Sensor and Reinstall it so it will again work properly. Eliminating the TROUBLE Lights on the temperature control assembly.
Troubleshoot and Repair Your Water Heater
Geofatboy

Leave a Reply

Your email address will not be published. Required fields are marked *